Granite

Hi all. Apologies if this has been raised before however: I have 2 x Saitek TQ's. I have mapped the throttle and CL to the appropriate axes. All good so far. The question now is this: I want to map beta (reverse) for engines 1 and 2 to the corresponding buttons below the throttle axes and the fuel cutoff to the buttons below the CL. The Saitek has a detent to pull the lever into which activates a button function. Any help appreciated. (and I am not that savvy with FWL scripts )

I stand to get shot down with the reply BUT I believe that each aircraft has its own joystick and button profile - you can set this in the joystick section. SO if Y is bound to yaw damper in the 340 profile it can be used for anything in different aircraft profiles.

Thanks for the update on this aircraft. Regarding the aggressive roll rate on AP (which I agree is way too aggressive) I also see vertical fluctuations as well. In the turn the aircraft will drop 100FT or so then when it corrects it will oscillate a few times at 1000fpm up or down to recapture altitude as selected. Again this is excessive vertical behaviour. When turning the AP should make allowance for the turn and maintain altitude. I will check this in 1.5.1 and report back.

deleted due my stupidity

Thanks for the assistance gents..I will take my rig to church come Sunday :-) Found the issue: I was using an old installer. Problem solved!

Hi all. I have an issue now in XPlane 10 when trying to load the 733. I have downloaded the latest version of the aircraft's I assume the hot fix has been incorporated? Now when I try to load the 733 in Plane 10 I get an error message saying the .acf file is either corrupted or not a real file and the sim just shuts down. Anyone else with this issue? or has anyone solved this issue? Thanks in advance