Finnharrier

Hi. Problem solved, by scenery update

Hi. Has anyone XP 10 Moscow City XP scenery. I landed Kremlin heliport and helo buried partly on it. Same thing with other helipad too. Is this familiar.

Hi. Thanks for help. I had ChaseViewDeluxe in Camera mode. That explanes all. Now it's in CVDMode again. I don't know, how this happen.

Hi. My X-P 10.45 started to act weird. When using Roll with my joystick, scenery is tilting, not plane.

Hi. I purchased New York Airports XP scenery it has six airports, static aircrafts and cars are missing. I've New York City XP one too, it has static helos and moving traffic.

Hi! Has anyone SBGL- Rio De Janeiro Intl Airport scenery. City buildings are missing

Commands are: Shift K and Shift L

Hi! I updated X-P 10.40 to 10.41, operation/time_down K tab and operation/time_up L tab doesn't respond.

Hi! How to get real traveling camera view in cockpit. I've Saitek X52 joystick Hat switch programmed to show Up + Down + Left + Right positions. Viewing look weird. Hard to get for example SeaMax M22 upper panel properly visible, problem to switch water rudder up and down.

Hi! I've PILATUS PC 12 v10np craft. I can open only front door with.. ( Button Adv. Flight _controls, Canopy toggle), not rear door and engine hatch.

Hi! Thanks your prompt reply. Here's Log.txt. Log.txt

Hi! I've X-P 10.31 and Bell 407 SP 1.1 craft is default I'm opening Quick Flight Setup, then Fly With Options! After waiting 1min 20 sec. craft at last appears, something weird happen immediately, at first craft acts un controllable with rotating interior view and then comes back normal cockpit view. After this, it works OK. Only this craft acts weird, when prepare to flight. How to get hanging headphone-mic. set visible. I can't get DREAM ENGINE volume display off.

Hi! Thanks your prompt reply. I'll wait SP 1.1.

Hi! I updated my Dreamfoil Bell 407 to Bell 407 SP1. I picked it as startup craft, It crash XP 10.32 some seconds later. No such a problem with Dreamfoil Bell 407.

Hi! You can get new version of K-1200 K-MAX from shadetreemicro.com. Ragards. Pertti

Hi! I sent e-mail for Jim McNeill today. I let you know. Regards. Pertti

Hi Jim! Thanks that you are agree with me. I light a bit back ground. I've always been interested in intermeshing rotor crafts, since I found FLETTNER one on my FSX. I browsed internet and found Kaman copter, with same tecnich, used WW2 FLETTNER one. K-MAX copter was available for X-PLANE simulator, so! I've got a king idea! I purchased both, copter and X-PLANE 10. During months I disappointed to struggling with crashes. Sad, good looking craft, etc. I'll give up and leave it in hangar corner, and starting to concentrate, for example Bell 407. Regards. Pertti

I've K-1200 K-MAX on XP10. I'm controlling it with Saitek X52 Flight controller set + Saitek pro Rudder pedal set. Throttle lever is using as a Collective. After increasing a bit power, when wheels are slightly off the surface, it's starting to spin slowly right and same time to start tilt right. After trying to prevent these unstable movements it crash! this isn't normal behavior for intermeshing rotor craft. I've FLETTNER FL-282 and K-1200 K-MAX on FSX, no controlling problems.

Hi! New update for XAdventures will come after x-mas.

Hi! I updated my X-PLANE to v 10.31 yesterday and then I updated DHC-3 Otters and installed Otter2 XAdventure among others. they didn’t respond. So, I reinstalling all of them, then tested one by one, loading went OK, loading was almost done to Mission is being loaded……then X-PLANE crashed, weird, same problem with other ones. Close XP. Regards Pertti

Control stick has red button for start pre-rotation. It must keep pressed for awhile, then main rotor start to rotate, problem is solved.

Hi! I've ELA 07S Autogyro on my X-PLANE 10.30. Mainrotor can't pre rotate. I can't find a way how to do it.

Case is closed!

Hi! When starting flight with floatplane on water, comes "Anchor Deployed " note. I push v button, then note disappears, but plane is still swinging hardly, how to avoid, or decrease this.

Hi! I'm fond of WIG / Ekranoplane crafts. I've AN-2 Ex for XP 8.60+ and AN-2 for XP10. AN-2 Ex one doesn't work causing An-2E.acf. Is it possible to make new AN-2 ekranoplane with XP Plane Maker, using these existing planes. For example remove AN-2 wings and add AN-2 Ex ones for it.