JGreen5278 Posted December 8, 2013 Report Posted December 8, 2013 Hello All, I normally don't do much posting, but since my searches have bore no fruit i figured this issue i've been having might be helpful in the future. After following the tutorial videos for WED I attempted to add two facades at KPIB however after adding the facades and selecting exporting scenery pack I start up X-plane only to be greeted with "Illegal dsf point type, Make sure your extension is .obj or .agp." Any ideas on this? I havent done anything that was not instructed by the tutorial "at least I don't think i did" any help would be greatly appreciated. Thanks! :-)
JGreen5278 Posted December 8, 2013 Author Report Posted December 8, 2013 *Updated* I ended up starting fresh without an overlay it seems to have worked now just have to figure out how to get rid of these tress on the tarmac.
chris k Posted December 8, 2013 Report Posted December 8, 2013 (edited) Exclusion zone. Big red [X] In the toolbar. Tick "Forests, Objects" on the bottom right window. Place big rectangle over the Tarmac. Edited December 8, 2013 by chris k
JGreen5278 Posted December 9, 2013 Author Report Posted December 9, 2013 Thank You sir, worked like a charm.
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now