SR22TN Fuel Boost/Prime switch not working correctly

[azpilot61]

V2.1.0 - SR22 Fuel Boost/Prime switch works fine with my 3 position switch. I have it set as follows below (would be better if we could have a boost / off / prime only selection to assign to each one) When starting up its aways on Prime and I just move to off and its all good and all three positions work fine

UP = Off/Boost
Middle = Off/Prime
Bottom = Off/Prime

Using the same setup in the SR22TN however, when loading the aircraft the switch starts in the prime position (same as SR22) but when I move to the off position with my hardware switch it does not go there it stays in Prime. If I move to the Boost position it then goes off. Its not acting the same as it does in the SR22 aircraft.

Log.txt file included, started with the SR22TN and tested it then to the SR22 where it worked fine.

Log.txt

Edited August 5, 2024 by azpilot61

[azpilot61]

Worked around the issue with the Prime and Boost function by not assigning the middle off button to anything. Although when moving from boost to off it does nothing, a click flip to prime springs the switch to the  off position, I can live with this.