Hi,
I have an issue with what seems to be a simulation of force limitation on the yoke.
The trim of the TBM is a trim tab (not a trimmable horizontal stabilizer), so the trim effect is mainly a force on the stick. I understand that in xplane this is handled as an offset of the zero of the joystick since a desktop joystick is always centered at the same position.
But on the TBM 900 there seems to be a "stick force limitation" effect.
For example on the ground I can have full deflection of the yoke. But in flight if I'm out of trim I can't reach full deflection. If I'm flying fast with tail heavy trim, then when I apply full forward joystick the yoke is not moving fully forward. I guess that this was made to simulate control force on the yoke and the limitation of the force of the pilot. Can you confirm that ?
Is there any way to disable that ? I'm using another plugin that controls the aircraft through yoke dref. I expect yoke full deflection (-1 or +1) to always correspond to a same stick position and therefore same surface deflection. But depending on the speed and trim setting, the yoke dref full deflection does not give the same yoke deflection on the cockpit and therefore not the same surface deflection.
EDIT : I found in another topic that the TBM plugin has its own custum trim system. Is there any way to disable it ? I read that DREF were supposed to be added to handle forcefeedback joystick like tbm900/fctl/elev/relative but I can't access those DREF.
Regards,
Thomas
