frankbuijck58

Thanks for the reply. Indeed I did not understand the instructions properly. But now I have followed the instructions as you can see from the pictures. However, another problem presents itself. I can't start the engines with this hardware connected. Without the hardware the engines start as normal. This has to do with the settings of detent or no detent. Unfortunately I am not a techie to understand this. I have tried to set the Hardware Power Detent Ratio correctly. I can't figure it out. There is no Switch on this throttle to set it to Reverse. It is simply pushing the lever down through the zero-level. Thanks again for your thoughts.

I have taken screenshot of the Joystick settings.

I looked at that too, but it didn't provide a solution. In other aircraft, TQ3 works properly It's just that throttle that MU-2 doesn't respond.

Yesterday I bought MU-2 Marquise. Followed the installation according to the procedure. So far no problem. Now I encounter the following problem: the throttle of TQ3 from Yoko does not seem to respond. Did I forget to install something somewhere. The Prop lever does respond. Who can help me with this. Thanks in advance.