Jump to content

ArturoJGT

Members
 View Profile  See their activity

  • Posts

    3

  • Joined

  • Last visited

ArturoJGT's Achievements

Newbie

Newbie (1/14)

  • One Year In
  • Conversation Starter Rare
  • First Post Rare
  • One Month Later
  • Week One Done

Recent Badges

0

Reputation

  1. ArturoJGT started following CitationJet 525 , Systems and Tech and Flying the Challenger
  2. ArturoJGT
    1- There are a few requirements for AP to be able to engage: The "Turn" knob must be centered on the AP control panel on the center pedestal. There is a clickspot on the knob that will center it for you as well. The attitude gyro must not be in fast erect mode. This is the lower left switch on the pilot's switch panel located to the left of the main pilot's displays The ATT2 gyro must not be enabled as the EADI source. This is the button underneath the DME power button on the pilot's panel. "ATT2" would show on the EADI if it is selected. The ATT1 gyro must be aligned. (If you see the horizon bars on the EADI, it is aligned) 2 ?
  3. ArturoJGT
    Estimados. 1- I'm unable to activate the AP. The plane is leveled, there are no warning lights, HDG and IAS are activated, and the yaw damper has a green light. However, when I press the AP button, two-tone chimes go off, and there is a momentary green light in the AP switch, but nothing more than that. The roll knob is centered. 2- The main configuration windows in 2d are not showing, only in VR.
  4. ArturoJGT
    You need to create no drt_ignore.txt file with notepad. I attached my file below. drt_ignore.txt
×
×
  • Create New...