ebbsy1

thx for reply all box`s are ticked and got the setting on hi i think rain and windshield icing are 1 box i get the rain texture but not seen the icing effect yet ive kept the wind shield heat of on purpose just to catch a glimpse of it

thx also left the yaw damper on for landing as well din`t notice till the replay.as for the flaps i done a few flights in the tbm and generally only use 1 notch of flaps but still tend to swerve on the runway on take off, that might be down to xplane as i have to recalibrate my controllers every time i start the pc and run xplane.but like i said in the earlier post when i reloaded xplane at boston and checked the maintenance tab everything was like new no damage to anything, as for the failure ive put it down to the landing gear icing up as it was pretty cold there today and as for the damage it was`nt actually a to hard landing so i got away with it.been simming for about 7 years now on and off first unscripted emergency landing ive done and loved every minute of it .after a smooth flight felt quite realistic to have a unplanned failure on the approach and having to react in real time.

its the full flight, you`ll see the checks at beginning of the vid showing all`s fine and the dodgy takeoff.i lower the gear at 2:57:10

hi thx for the amazing aircraft really enjoying flying the tbm hear`s the story took off from cyam to kbos did the preflight maintenance engine landing gear everything as new apart from brake pads witch read as good.startup and taxi all went well take off was a bit dodgy swerving left right after about 50 knots but managed to get in the air 85 knots.flight went smooth climbed to 29000 and followed the flight plan from simbrief no issue.decent into boston was 1500 fpm with no over speed and about 5 miles from the approach turn i started to slow to 125.turn went well and i tried a slightly different procedure for me were i dropped the landing gear on the glide slope at 1500 ft. nose and left gear lowered successfully but the right gear stuck. i tried the emergency gear lever on the floor but this did not solve the failed landing gear',also i tried raising and lowering the landing gear but the right gear did not lower.i did a quite successful emergency landing(witch i streamed on youtube) landed on the 2 wheels no probs until almost stopped then the plane veird off to the right slowly and the wing slowly dropped to the floor. i then powered down went to the maintenance tab could not check the gear as it said the gear was still retracted so i reloaded the plain at Boston and the plane looked ok checked the maintenance and air-frame engine and gear and all was like new

hi using saitek yoke and throttle.on the tbm throttle quadrant theres a switch underneath that you pull to allow you to go to taxi mode is the a button i can configure to this instead of just pulling the saitek into reverse then up to taxi

hi i dont seem to be getting icing effect on the windshield . ive got visual effects set to high the rain works but no icing effect on the windows.currently at 29000 ft in the sim -40c and switched window heat off but even when i fly through cloud the windshield does not ice up

replaced bat all working fine now.must of been pilot error lol but it did this 2 times on trot only had the plane for a few days i never did that on earlier version. i think is was the switch as i have a double click issue with the mouse. thx for the help

yes done that. reset the gen mfd flashed for a few min but still got the low voltage and main gen warning on pfd. landing in 10 min ill check maintenance again when landed replace battery and let you know thx for your help

hi thx for reply looked in there cant see anything wrong all components listed as new even installed new airframe same issue.on my way to eham atm mfd listed cas low voltage main gen gen just isn`t pulling any power

installed update generator not functioning while inflight i get low voltage message backup gen also not working