BobFam

Hi Eric. I sent you an e-mail. Thanks for the offer. Regards, Bob.

Is there any Help or Tutorial files later than the Scribus 1.3.3.9 WED117.tmpWEDManual.pdf file? That file is lacking in a lot of details and seems outdated. It is a good start. I see an entry of Preferences in the WED File Menu that is not even mentioned in the PDF. Also there are right facing solid arrows and up facing solid arrows that don't show in the PDF. I finally got all of the corners coordinates inputted by using CTRL and a left mouse click on all of the corners. This trick is not mentioned either. I am stuck trying to create the airport with runways, etc. If any kind soul that knows WED could contact me via PM I'd sure appreciate it. Best regards, Bob.

I am trying to use WED to make an Area 51 airport. I have an overlay in png form. I can import it into WED but when I try to input the coordinates of the four corners the image gets all skewed and finally ends up as a line when I input the second set of coordinates. I cannot figure out how to input all of the coordinates. I followed the manual and entered the points as P1, P2, etc. When I click on the corners of the image there are latitude and longitude already in the box that I am inputting the coordinates. I just overwrote the coordinates. Is there something I am doing wrong or something missing in what I have done? Thanks for any help. Regards, Bob.

Hi to all that answered my post. I appreciate the help. I'll try all the suggestions. Regards, Bob.

When I select the 3D panel either with the mouse or by CTRL-O and I move the mouse the panel does not stay stationary. It moves all over the place. How can I stop the panel from moving so I can use the mouse to adjust the autopilot, etc? Sorry but I am a very new user. I am used to the way the 3D panel works in FSX and FS9. Regards, Bob.

Hi. OK. Thanks for the tip. Regards, Bob.

I have my joystick hat switch setup to pan left and right. I don't see a way to setup the hat switch to pan up and down. When I did set it up for up/dn it reverts back to the 3D panel and not the spot or circle view. How can I pan up and down in circle or spot views? Regards, Bob.