Agrajag Posted February 23, 2014 Report Posted February 23, 2014 So, while flying a route from KORD to KMSP (via VATSIM), all was totally fine. Third flight of the day. No incidents at all. I'm closing in on a VOR (EAU) when I notice the plane (FlyJSim Dash) is suddenly just deciding to bank hard right. I wrestle it back. I turn of AP. I set up everything again. I engage AP and the plane immediately tries to climb at 25 degrees up (or more) and bank right again. No NAV, HDG or any AP entry will work. I ended up just manually flying into MSP from EAU all the while fighting the plane. I notice the elevator trim is all the way up. I get that fixed and just set a HDG and follow it manually. How can I go about finding out what caused this as, clearly, I'd rather not have it happen again. What did I add to the mix? Well, I had just bought X-Mapper Pro for my iPad but I hadn't touched it other than to zoom in as I got closer to my destination. Sent from my SCH-I545 using Tapatalk Quote
ScottVal Posted July 13, 2014 Report Posted July 13, 2014 I've been flying the FJS Dash for a little while, and I've noticed the AP is a bit squirrely too. I'm not sure what to say, other than have you tried the FJS forum or support? Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.