HotStart Challanger 650 Sim locks up in XP12

[Car147]

Hi

I hope i can get some help with this issue. Everything was fine until i enabled Zink a month or so ago. It caused issues and i got help advising me to not use it, and disabled it ever since.

Now ever since, the sim freezes or locks up sometimes as early as programming the FMS, (usually on a key press) other times i will get airborne. only to switch view and  bam! Locked up.

Actions taken so far... Disabled Zink, then removed all addons.. Still the same. Then i did a clean install of XP12 on another drive, and used a fresh download of the Challenger 650. with nothing else installed. so far i am yet to get a flight in again. with similar results to before, with either locking up entering data into the fms or changing view just after TO.

Totally baffled now as all other aircraft Toliss, FF, etc all work fine.

Any advice appreciated.

 

Log.txt

Log New Installation, no addons.txt

Edited May 20, 2023 by Car147
Forgot to add Log

[Car147]

Well i am glad i didn't give up on fixing this issue... And i take it there's no support at weekends here. Luckily i remembered one of the early issues with MSFS was if you had any form of overclocking it would result in CTD's for a lot of folks. I checked the Bios, and i must have turned XMP on at some point after that earlier issue was solved.

Now done two flights with no issues on the extra XP12 installation with just the Challenger 650 and Avitab installed. Full flight planned tomorrow.

Hope it helps someone in the future if they come across this issue on AMD Systems.