Hi, I don't have a great stick yet so no button mappings are in the way. Then only trim axis assigned is rudder. The standard G1000 AP works in all of my other planes with the same stick mapping. Failures are disabled, I have no interest in dealing with those yet, want a perfect plane every time I fly (for now),
The AP trim switch on on (done both as part of the built in checklist and startup the tutorial). I also went through every subsystem to make "as new" as well as just creating a new airframe just in case the issue followed the plane.
I'm not sure about scripts, I don't think so. Again, everything works fine in every other plane following the same G1000 procedures.
I'll install it in a fresh, virgin install of X-Plane 11.4b3, see if it magically starts working, and report back.
If you have anything else to check or post let me know.