Jump to content

Leaderboard

Popular Content

Showing content with the highest reputation on 10/18/2020 in all areas

  1. Since the release of the Take Command! SR22 Series, we have been hard at work adding features, fixing bugs, and making general improvements throughout! We are preparing to enter a Public Beta in the coming days (if you are interested in being a part of the Public Beta, you can sign up for a spot here – Note: spots are limited), followed by a general release to everyone once it is ready! Here are some of the key features we have implemented: G1000 Terrain Profile Indicator We have integrated a custom terrain profile indicator on the MFD. This will help for situational awareness, especially in mountainous terrain, and help prevent CFIT incidents. The custom system is entirely multi-threaded to prevent any performance penalty. Visual Icing Effects We have been hard at work adding custom visual icing effects to the aircraft! This will help with situational awareness surrounding the use of TKS during icing conditions, as the simulated ice can now be seen on the wing, inlets, windshield, spinner, and other relevant surfaces! Engine and System Model Improvements There have been many improvements made to the engine model and system model. Here are a few highlighted findings from our debugging and fixing: SR22TN Power Fluctuations There was an issue leading to potentially severe fluctuations of engine power during takeoff and climb at high ambient temperatures and altitudes, on the SR22TN only. The cause of this issue has been eliminated. However, there may still be minor residual fluctuations on takeoff and initial climb under such conditions, largely attributed to mixture being slightly too rich for such higher density altitude takeoffs. It can be further amplified by too quick movements of the power lever. To get rid of any remaining fluctuations altogether, embrace the following steps when setting takeoff power at high temperatures and/or density altitudes: Advance power slowly until the point where RPM rises above 2500 RPM (around 80% lever travel) and wait for manifold pressure to stabilize. This will take a few moments at altitude and is particularly important up there. Start your takeoff roll and simultaneously advance power slowly to maximum. Procedures allow you to lean the mixture to 34GPH for takeoff on hot days. It is suggested to follow this step at OATs in excess of 30-35°C to eliminate any residual power fluctuations. Advance the mixture to full rich after obstacles are cleared. Also keep in mind that it is normal for the turbo-normalized engine to slightly fluctuate for a few moments after power changes before all parameters stabilize. Thus it is generally recommended to make power changes slowly on such engines, so even during go-arounds better take 2-3 seconds to advance to full power. Random engine cutout during taxi There was an issue leading to seemingly random engine quits during taxi. A fix is in place that has proven to work in internal tests. Engine starting The fuel-injected IO-550 engine can be challenging to start at times, so video tutorials to prepare you for all kinds of cold, hot and flooded starts you may face. We have also seen the most typical cause relates to mispositioning the power lever for engine starting (some even at maximum), keep in mind to set the lever to about 1/4” (i.e. at or slightly above the letter R in POWER). We have determined that there is no issue with the custom engine model. Engine cutout after landing When landing at higher density altitudes with the power lever at idle on rollout, it is to be expected that the engine may not be able to hold its idle RPM due to an excessively rich mixture. Lean the mixture to the appropriate X-T letters in MIXTURE immediately after landing and try to keep the power slightly higher than low idle to prevent the engine from quitting in such situations. We have determined that there is no issue with the custom engine model.
    1 point
×
×
  • Create New...