JGreen5278 Posted December 8, 2013 Report Share Posted December 8, 2013 Hello All, I normally don't do much posting, but since my searches have bore no fruit i figured this issue i've been having might be helpful in the future. After following the tutorial videos for WED I attempted to add two facades at KPIB however after adding the facades and selecting exporting scenery pack I start up X-plane only to be greeted with "Illegal dsf point type, Make sure your extension is .obj or .agp." Any ideas on this? I havent done anything that was not instructed by the tutorial "at least I don't think i did" any help would be greatly appreciated. Thanks! :-) Quote Link to comment Share on other sites More sharing options...
JGreen5278 Posted December 8, 2013 Author Report Share Posted December 8, 2013 *Updated* I ended up starting fresh without an overlay it seems to have worked now just have to figure out how to get rid of these tress on the tarmac. Quote Link to comment Share on other sites More sharing options...
chris k Posted December 8, 2013 Report Share Posted December 8, 2013 (edited) Exclusion zone. Big red [X] In the toolbar. Tick "Forests, Objects" on the bottom right window. Place big rectangle over the Tarmac. Edited December 8, 2013 by chris k Quote Link to comment Share on other sites More sharing options...
JGreen5278 Posted December 9, 2013 Author Report Share Posted December 9, 2013 Thank You sir, worked like a charm. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.