Re-installed and can not get no bezel popout to mount in realsim gear G5 hardware properly

[dbueffel]

I have been using the AFM G5 for a while. I re-installed the plugin this week and now I can not get it to mount in the realsimgear G5 correctly. I am doing this in default 172 with G5. I get white bars at the top and when manually make them larger the white bar will not go away. I have played with the cfg file and can get it to move on the x axis correctly but when I change the y axis values it does not move vertically. It is almost like it is not reading the y axis values from the cfg file. I have attached my images and the log file for assistance. I am running version 1.0 of the AFM G5 and 3.1.9 if RSG G5. My monitor resolution is 1920x1080 and used the formulas to get it to place the images correctly. Image one - x axis moved from when it should be, image 2 manually mount and enlarge, image 3 what I see what after aircraft load.

thoughts?

Thanks for the assistance - David

Log.txt acfConfig.cfg

Edited January 10, 2021 by dbueffel
identify images

[Coop]

What is the arrangement of the monitors you have set in Windows Settings? Additionally, are you running X-Plane in full-screen or Windowed mode?

I assume you have followed RealSimGear's settings guide: http://help.realsimgear.com/en/articles/3737083-setup-for-the-realsimgear-g5

[dbueffel]

Coop,

Screen layout image below but as per RealSimGear recommendation. Yes, I have followed and installed per their recommendations. I reached out to them first when I noticed the issue thinking it may have been their issue since it just started happening after I re-installed the AFM plugin.

I am running full screen mode.

I can un-install and start over if you think it will make any difference. Thanks for the help.

 

 

Edited January 11, 2021 by dbueffel
updated to answer all questions