Jump to content

trim trim and trim


txnoodles
 Share

Recommended Posts

I have problems on take off.Even if  the sr22 is trimmed for take off the plane balloons up as soon as I take off and banks slightly left.Trimming the ailerons is even worse because I can't get the top edge lined up with the zero.It's hard to see.

Any hint or tip ?

Thanks

Link to comment
Share on other sites

  • 2 months later...

Start to slowly rotate just before reaching 70 and the climb out will be smooth.  Banking slightly left is normal, especially on a high-torque engine.  When you use rudder to accellerate down the runway, you may find that just a bit MORE rudder is used when you rotate due to gyroscopic precesssion. This is a well balanced behavior compared to many addon models I have.  Also, don't forget to consider wind effects.

Edited by Aleksandar
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
 Share

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...