kjhkent Posted November 1, 2018 Report Share Posted November 1, 2018 Just a heads up. I appreciate its a beta but 11.30b2 breaks the TBM. It will load but the side buttons for air frame, maintainence etc are all over the place and not easilly selectable. I am reverting back to 11.30 b1 where I personally had very few issues. 1 Quote Link to comment Share on other sites More sharing options...
cpuwolf Posted November 1, 2018 Report Share Posted November 1, 2018 as far as I know, beta will not be supported by any aircraft manufacture. Quote Link to comment Share on other sites More sharing options...
kjhkent Posted November 1, 2018 Author Report Share Posted November 1, 2018 15 minutes ago, cpuwolf said: as far as I know, beta will not be supported by any aircraft manufacture. I know. Not expected. Quote Link to comment Share on other sites More sharing options...
sdflyer Posted November 1, 2018 Report Share Posted November 1, 2018 Just a heads up. I appreciate its a beta but 11.30b2 breaks the TBM. It will load but the side buttons for air frame, maintainence etc are all over the place and not easilly selectable. I am reverting back to 11.30 b1 where I personally had very few issues. That what I had in 11.26 with scaling anything other than 100%Sent from my iPhone using Tapatalk Quote Link to comment Share on other sites More sharing options...
sd_flyer Posted November 2, 2018 Report Share Posted November 2, 2018 FYI I just install 11.30b2 and o problem with the menu. As i suspected it's probably the same issue with scaling as it was upon release - anything above 100% get menu screw up Quote Link to comment Share on other sites More sharing options...
deimos256 Posted November 2, 2018 Report Share Posted November 2, 2018 Not sure if it's related but after updating to 11.30b2 I ca'n't get the plane started anymore. I move the throttle out of cut-off and get a warning about fuel residue, replace the part, try to start again, same result. Quote Link to comment Share on other sites More sharing options...
kjhkent Posted November 2, 2018 Author Report Share Posted November 2, 2018 1 hour ago, deimos256 said: Not sure if it's related but after updating to 11.30b2 I ca'n't get the plane started anymore. I move the throttle out of cut-off and get a warning about fuel residue, replace the part, try to start again, same result. Make sure that the red manual overide lever is fully forward. Quote Link to comment Share on other sites More sharing options...
Smiley0201 Posted November 2, 2018 Report Share Posted November 2, 2018 Red lever must be fully backwards, not forward. Full forward will introduce fuel and flood the engine in no time... Quote Link to comment Share on other sites More sharing options...
kjhkent Posted November 2, 2018 Author Report Share Posted November 2, 2018 12 minutes ago, Smiley0201 said: Red lever must be fully backwards, not forward. Full forward will introduce fuel and flood the engine in no time... Thanks for the correction. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.