Martin D. Posted May 7, 2016 Report Share Posted May 7, 2016 Hello, can i help me with lighting on B733. How is procedures for specific lights during different phases(taxing, on runway etc.)? which light have i use. when i walk into the aircraft? when i preparing aircraft? before start up? after start up/before taxi? taxi? before taxi on the runway/before take off? after take off/after passing 10 000ft? Cruise? Descent/after passing 10 000ft? Short final? After landing/vacated runway? Shuting down? Thank you very much. Martin. Quote Link to comment Share on other sites More sharing options...
Vantskruv Posted May 7, 2016 Report Share Posted May 7, 2016 I'm guessing here: * Preparing Aircraft - NAVIGATION lights * Before startup or pushback - ANTI-COLLISION lights * Taxi - TAXI and left and right RUNWAY TURNOFF lights * Crossing/entering runway - STROBE lights * Before takeoff - Inner LANDING lights to ON, TAXI lights to OFF * Climbing FL100 Transition - Turn OFF inner landing lights and left and right RWY TURNOFF * Descending FL100 Transition - Turn ON inner LANDING lights and left and right RWY TURNOFF * Approaching runway - Extend and turn ON outer LANDING lights * Exiting runway - Turn ON TAXI lights, retract and turn OFF LANDING lights, turn off STROBE lights * Approaching gate - Turn off TAXI and RWY TURNOFF lights * Shutting down engines - Turn off ANTI-COLLISION lights Wing and logo lights may be set whenever if it is dark. 1 Quote Link to comment Share on other sites More sharing options...
Martin D. Posted May 7, 2016 Author Report Share Posted May 7, 2016 Thank you. M. Quote Link to comment Share on other sites More sharing options...
stefans85 Posted May 23, 2016 Report Share Posted May 23, 2016 SOP: - Navigation light on all times if crew is on board and aircraft powered - Logolights on when applicable (dark) and <10.000 feet - Turn on Anti collision as a warning for ground personell before spooling engines - Taxi light on all times when taxiing and switching off before turnin into parking position (thats nice for the ground persons) - Runway Turnoff everytime when needed (dark and not an apron where you don't have airport lights) - Strobe and Landinglight on before starting takeoff roll (doing lights and chronometer to run the same time while wating for spoolup to 40% N1) Do NOT use turnoff and landing light the same time for more than 5 minutes or you'll light up the bulbs. - Turn off Taxi light after gear up - Switch off all lights but strobe, nav and collision when reaching 10.000 feet. Wheel well is used only for ground check or by maintenance personell. The outboard landing lights are only used at night. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.