[TCAS would not activate]

Hi Captain Litjan,

Many thanks for your response.

In fact I haven't noticed that the Xponder mode switch, which is on the top left of it, was in off position....Silly mistake.

In fact, I have never touched that switch, only activating Xponder by means of the switch STBY/AUTO/ON switch.

Once shifted to TA/RA position, TFC mode immediately showed up again on ND.

Thanks for your help and time!

Cheers.

[TCAS would not activate]

Hi guys,

Sorry if this subject have already been covered here, but I just can't seem to succeed in turning TCAS ON, even after tkofs, having checked Xponder is in ALT mode...

I use to hit TCAS button on central panel, but dont't have any answer.

Any help on this?

Tks,

Luiz Antonio

[Airac updating]

Hi mmerelles,

 

I have the IXEG 733 listed in Navigraph when I open "addon mappings".

My IXEG B733 is located at Xplane's folder's root, as recommended.

I updated X-plane with AIRAC 1706, as well.

I have restarted X-plane too, but no changes in the AIRAC 1509, shown on IXEG 733 FMC.

Tks,

Luiz

47 minutes ago, mmerelles said:

double check were the navigraph manager is installing the update

 

it should go to .../IXEG 737 Classic/fmc_data/ (that is were the aircraft loads from)

 

maybe it is installing to another folder, the aircraft should be within Xplane11/Aircraft/x-aviation/737 Classic (not on the root folder (maybe you are confusing the uninstaller there?)

Great, mmerelles.

A couple of minutes before reading this last repply of yours I managed to directly load the update in the folder you mentioned.

Now it shows AIRAC 1706 on the IXEG FMC.

I am very thankful for the time you spent and for this valuable help.

Good skies for us.

Tks,

Luiz 

[Airac updating]

Hi mmerelles,

 

I have the IXEG 733 listed in Navigraph when I open "addon mappings".

My IXEG B733 is located at Xplane's folder's root, as recommended.

I updated X-plane with AIRAC 1706, as well.

I have restarted X-plane too, but no changes in the AIRAC 1509, shown on IXEG 733 FMC.

Tks,

Luiz

[Airac updating]

Hi everyone,

Having recently updated the IXEG 733 to version 1.1, and after updating AIRAC to 1706 cycle, I've found that some waypoints that used to exist in the previous version are no longer recognized by the FMC.

After taking a look at the INIT page, FMC shows AIRAC 1509!

I managed to update AIRAC directly from Navigraph and think it's allright.

Any help on this?

Tks,

 

Luiz