Jump to content

BAW958

Members
  • Posts

    3
  • Joined

  • Last visited

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

BAW958's Achievements

Newbie

Newbie (1/14)

  • Conversation Starter Rare
  • Week One Done
  • One Month Later
  • One Year In

Recent Badges

0

Reputation

  1. Hi, as always i try to fly a aircraft by hand. No AP. But the Challenger is very hard to fly without the AP. The plane is hard to trim. Elevatortrim 1.2 the plane goes always down, trim to 1.4 goes always up. Speed is 240 kts. I also have to trim the ruddertrim always 1 left. Otherwise the plane goes to the right. Any ideas what i am doing wrong? I use hotas warthog Greetings Mike
  2. Hi, thank you for the answers and the link. best. greetings Markus
  3. Hi, I did a mistake in cockpit preparation. I had fuel in center tank and wing tanks. But i forgot tu switch on de pumps for center tank. After two ours of flight the wing tanks were running out of fuel and the engines went out. After a few minutes i came back to the simulator and the autopilot was off duty and also autothrottle. The plane was in a descent and turned to th right side. I stabilised the plane and tryed to restart the engines with fuel in the center tank only. APU could not be startet for some reason. Of cours i switchted the center tank fuel pump to "on" . But i could not start the engines. After a short time i lost also the power of the batterie. So i tryed to land without any power. I tryed to lower the gear by using the three levers behind the pedestral. No effect. So did a very hard landing beside the rwy. My question is: Is it normal that i can not restart the engines with center fuel only? Why did i not receive any failure because i had not engaged the fuel pumps for center tank? Greetings markus
×
×
  • Create New...