1.1.6 TBM900[libsvs.c:3744] CTD [SOLVED]

[Nullpoint]

Hi,

I just upgraded the TBM to 1.1.6 and now experience near consistent CTD.  The backtrace points to:

2019-03-18 22:08:00 TBM900[libsvs.c:3744]: assertion "!(__builtin_choose_expr ( __builtin_types_compatible_p (__typeof__ ((rev_dir_v).x), double), __isnan((rev_dir_v).x), __builtin_choose_expr ( __builtin_types_compatible_p (__typeof__ ((rev_dir_v).x), float), __isnanf((rev_dir_v).x), __builtin_choose_expr ( __builtin_types_compatible_p (__typeof__ ((rev_dir_v).x), long double), __isnanl((rev_dir_v).x), (__builtin_trap(),(rev_dir_v).x)))))" failed: 

Initially I was seeing the CTD at what appeared just before the alignment completed (it went from the aligning message to a red cross across the PFD horizon, then immediately crashed).  The next day I tried again and now basically get CTD after dismissing the reset flight prompt (because it crashed on a "flight" during the inital CTDs).

I have tried the following variations of running the aircraft (mostly in order):

1. Running as I have X-Plane configured
2. Running without any third-party plugins (except Gizmo)
3. Remove all Hot Start file artifacts (as far as I know) and reinstall
4. Running X-Plane with my second monitor turned off (i.e. not extended to)
5. Starting from a default XP aircraft and airport

Looking forward to running this again,

-Bryant

Log.txt

Edited March 21, 2019 by skiselkov

[Nullpoint]

The 1.1.7 update appears to have resolved this issue.

-Bryant