Jump to content

TBM-900 Crashes FLT Plan Enter


nboggs70
 Share

Recommended Posts

On ‎2‎/‎10‎/‎2019 at 12:36 PM, nboggs70 said:

TBM-900 causing x-plane to crash when entering a flight plan on the MFD and I hit the "ENT" button.  Anyone else having this issue?  Any suggestions?  I'm guessing may be related to x-plane update.  

 

1 hour ago, GliderPilot said:

Hi yes I am having the same when I try to enter a flight plan.  I think it might be with  XP11.31 update. it was fine until the update

@nboggs70 & @GliderPilot  The problem your having is being addressed by the TBM-900 developer's, and an update is in the works and said to be a day or so out.

If you want to fly in the meantime, follow the instructions as listed below:

1. Open X-Plane 11 and select a GA aircraft such as the Cessna C-172 / G1000

2. Open the FPL and clear any flight plan, or procedure shown. You should then only have the airport identifier shown for the current location i.e. Orlando, FL  KMCO

3. Close the C172 /G1000.

4. Open the TBM-900 and you should be able to fly.

5. Some people have been able to load a flight plan/procedures into the C172 /G1000 and after closing have the TBM now loaded with that flight plan not CTD (Crash To Desktop).

6. Any entry made to the G1000 will likely cause the CTD when the ENT key is pressed to activate in the TBM-900. This has happened to me repeatedly since the XP 11.31 update.

7. If this works for you, go fly, have fun! It works for me and you only have to open the C172 /G1000 once provided you don't mess with the ENT key on either the PFD or MFD.

For more info check out the Hotstart  Forum for TBM900 Support. As I said support is actively working this issue.

Good luck!

Edited by DwightP980
add info
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
 Share

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...