Airplane goes full blast on TOD

[Tchou]

Hello, 

I flew the IXEG this morning, and had some issues, I don't know if it's due to VNAV, or other cause. 

I was flying this Flight plan BRU604 RJSR-RJCW (10-Feb-2018) #1.txt

First Issue was when inserting routes/airways from the route page everything seemed fine, BUT when reviewing the flightplan I had the waypoint CHE doubled and there was something wrong with the distances: 

I managed to overcome this issue by entering the points one by one. 

but then comes the fun part : 

The flight did go OK, i was on vatsim, and everything was OK until I reached the TOD

When entering the star, the FMC told me I was at 10Nm from TOD, I didn't have the message to reset MCP altitude, I suppose I was too close for it to appear. 

I didn't have time to reset the Altitude, while I was checking on charts, I reached TOD, at that point, instead of Keeping the same speed, the AT kicked in full throttle, 

I dialed a lower altitude but had to disable AT to regain some control and manually Idle the throttle 

At that point here is the result : 

I hope that helps finding issues. 

Here is the Log.txt file from this flight

Log.txt

I finished my flight manually, and it went well from this point

Edited February 10, 2018 by Tchou

[Litjan]

Hi Tchou,

46.022 kts, eh? That must be some derelict testing mode that Tom was using, he gets tired of waiting for the plane to arrive...

I will try to recreate your scenario and bug, thanks for the report!

Cheers, Jan

 

[Tchou]

2 hours ago, Litjan said:

Hi Tchou,

46.022 kts, eh? That must be some derelict testing mode that Tom was using, he gets tired of waiting for the plane to arrive...

I will try to recreate your scenario and bug, thanks for the report!

Cheers, Jan

 

I though you were developping a Falcon Heavy Rocket in disguize of a 733...  or maybe next step, the BFR... 

Edited February 11, 2018 by Tchou