Jump to content
aleksfacco

Engines always hot start

Recommended Posts

I just got the Jetstream 32, and every time I have tried it the engines will hot start (to the point where the needle is spinning multiple times around the dial for egt). I have tried following both the manual and the tutorial you put on YouTube, with the same results. The engines always come down in temperature after going super high, but then when I disconnect the GPU (I've tried using the stop button as well), everything loses power even when the generators are on. I've tried reinstalling XPlane and getting rid of all my plugins, but the result is still the same. I believe I am version 11.11 of xplane 11. I don't believe its a hardware issue, because I'm running on an i7-8700k and gtx-1070ti, and other addons (RotateSim Md-80) work fine. Any help would be appreciated.

Log.txt

Edit: I've also tried redownloading the Jetstream (I bought it on XPlane.org), with the same results

Edited by aleksfacco

Share this post


Link to post
Share on other sites

Does the aircraft appear to work ok if you load it engines running?
If so, the most probable cause of a 'hot start' when you try and start the engines yourself (from 'cold & dark'), is 'pilot error' or incorrectly setup  addon's eg. 3rd party, switch panels, control yokes, joysticks etc.

cessna729.

Share this post


Link to post
Share on other sites

No, I tried that and they just shut down to a state like if you did a cold start. And all I have is a Logitech X3D pro, but I do all the engine starting with the mouse. I've also read the manual and watched his tutorial and done everything exactly as it says to and I still get hot starts

Edit: While trying to load the aircraft with the engines running while xplane is 'running' (I loaded the aircraft in first without engines running to see if the problem was still there), when you load it with the engines running at the beginning it seems to be fine. I'm still trying to figure out what I was doing wrong trying to start it up cold and dark. Thanks for the help

Edited by aleksfacco
Update on problem

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Recently Browsing   0 members

    No registered users viewing this page.

×