Jump to content

Huge speed value on MCP


admroz
 Share

Recommended Posts

First and foremost, the problem was caused by my mistake. I forgot to retract flaps and in CRZ the plane started to switch between FMC SPD and MCP SPD (probably caused by flaps speed limits). The problem is that while in MCP SPD mode it shows really huge speed value. I am also not sure what should be the proper plane reaction for such a pilot error.

B733_17.jpg

B733_18.jpg

Link to comment
Share on other sites

10 hours ago, Morten said:

Flap overspeed, blown flaps with following control problems and likely bad ending...

Think maybe X-Plane simulates that if you enable it the failure settings..

You're right, I enabled "Remove flying surfaces when over speed" (disabled by default? I don't know...) and really bad things happened :lol:

It seems to be not possible to overspeed flaps in VNAV in such scenario (which is good). During CLB there is SPD REST in FMC for flaps and it keeps the limit. Then in CRZ the plane accelerates in FMC SPD mode up to "red tape" and then switches to MCP SPD and slows down, then again FMC SPD, etc.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
 Share

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...