dlagoss Posted October 9, 2016 Report Share Posted October 9, 2016 Hi Guys All configured & when ascending over 2500 acl i active vnav & lnav, next cmd A y show this. If active first CMD A the same. When deactive cmd A or B this yellow msg are off. Before any of this happened and operate normally. Regards Quote Link to comment Share on other sites More sharing options...
Morten Posted October 9, 2016 Report Share Posted October 9, 2016 If you move your controls (yoke/joystick) while the AP is ON, the AP takes this as a signal that you want to override the autopilot, and it then goes into CWS mode (Control Wheel Steering). Constant pitch or roll. So if you accidentally bump into your controls with AP on this will happen. it CAN also happen if your hardware is not the best and sending signals (spikes) when it is not supposed to. If so try to increase the null-zone in the settings. Quote Link to comment Share on other sites More sharing options...
dlagoss Posted October 9, 2016 Author Report Share Posted October 9, 2016 15 hours ago, Morten said: If you move your controls (yoke/joystick) while the AP is ON, the AP takes this as a signal that you want to override the autopilot, and it then goes into CWS mode (Control Wheel Steering). Constant pitch or roll. So if you accidentally bump into your controls with AP on this will happen. it CAN also happen if your hardware is not the best and sending signals (spikes) when it is not supposed to. If so try to increase the null-zone in the settings. Thanks I increased the null-zone. Now all fine. Regards Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.